Scytek electronic 2000RS Manuel télécharger pdf (Page 22)

Page 18 - Galaxy 2000RS-2W

12. Engine Run Time. Selects between 15 or 25 minutes for the remote start run cycle.

13. Automatic Start Mode. Selects between every two hours or every hour for the automatic engine

starting feature.

14. Engine Sense Mode. Selects between Tachless and Tach Monitor operation.

achless. Determines the engine status using an advanced software routine, without requiring

connection to the vehicle’s tachometer. Tachless operation may not be compatible with some vehicles

or in severe temperatures, in which case the tach wire must be connected.

ach Monitor. Monitors the vehicle’s tach wire (or a fuel injection wire) in real-time to determine engine

status and adjust starter crank time automatically. If programmed for Tach Monitor, the vehicle’s tach

signal will have to be learned before initial operation (see below).

15. Remote Start Program. This dual program branch sets the engine mode for Gas or Diesel, and

learns the vehicle’s RPM threshold. For installation into a diesel equipped vehicle, first set the engine

type to diesel before learning RPM.

RPM Learn.

After engine type is set, start the engine, re-enter Branch 15, LED will start flashing if tach

signal is detected, otherwise the LED will stay solid. Press Button 1 to learn the vehicle’s idle speed.

The siren will chirp once to confirm. The siren will chirp four times if the tach signal was not learned.

Gas Engine.

Sets the engine type for Gasoline.

Diesel Engine.

Sets the engine type for Diesel and monitors the glow plug input to make sure the glow

plugs are warm before cranking the starter. If the glow plug wire is not connected, the built-in timer

waits 15 seconds before automatically cranking the starter.

16. Ignition 2 Relay Program. Selects one of three operating modes for the Ignition 2 relay output:

Ignition 2, Accessory 2, or Starter 2.

17. Horn Output. When set for Horn Output the horn wire will pulse when the alarm is triggered. When

Ignition 3 Output is selected, the output will activate during remote start to trigger a relay for Ignition 3.

18. Turbo Timer. When enabled, if the emergency brake has been applied Ignition power will be kept On

for a predetermined time (2min. Factory Default) from the application of the emergency brake.

19. Extended Parking Lights. When Enabled, upon Disarming Parking lights will turn On for 30 seconds

or untill the Dome light turns Off.

20. Horn Chirp Mode. Normal mode - sets horn chirp timing for most vehicles. Extende mode - extendes

horn chirp for vehicles that require longer horn chirp timing.

21. Key-Less Entry Chirps. When enabled, system chirps when lock or anlock are activated using remote

control. When disabled, no chirps will sound upon lock or unlock.

22. Remote Start Confirmation Chirps. When enabled, system chirps before starter activated. When

disabled, no chirps will sound upon start.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Scytek electronic 2000RS Manuel Page 22